GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-5
Section 3-3 Receiving and Unpacking the Equipment (cont’d)
3-3-1 Unpacking Procedure
1.) Loosen the screws and then remove the top cover from the crate.
2.) Remove the packing slip (see: Figure 3-2) detailing the contents of the shipping crate and keep
close to hand, ready to check whether delivery is complete (according to packing list).
3.) Remove the surface packing material (bubble packs, foam sections, silica gel, etc.).
Continue to remove additional packing material as applicable during the following procedure steps.
4.) Carefully remove the boxes containing the Voluson i / Voluson e scanner, peripherals, probes, etc.
as well as the package containing further accessories (e.g. cables and software CD).
5.) Before commencing the installation procedure, check visual damage!
Figure 3-3 Shipping crate - Voluson i / Voluson e with Peripherals
!! CAUTION:
When using sharp tools to open packing materials, take care to avoid cutting or damaging any
of the contents.
Figure 3-4 Shipping crate with Top open
Wooden Base
top cover
of crate
To Next Page
Loading...
