GE Voluson i BT06 - Tray Lower - Removal Procedure; Tray Lower - Installation Procedure

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-47
8-19-3 Replacement of the Tray lower
8-19-3-1 Manpower
One person, 10 minutes
8-19-3-2 Tools
Phillips screwdriver 1
Allen wrench 5
8-19-3-3 Preparation
1.) Put away all things on the Tray (e.g. Printer).
8-19-3-4 Tray lower - Removal Procedure
1.) Loosen the 4 Allen screws that fasten the Tray lower and carefully remove it.
2.) On the back side of the Tray screw off the 6 screws and you have the Tray only.
8-19-3-5 Tray lower - Installation Procedure
1.) Place the new Tray and fasten with the 4 Allen screws (as shown in Figure 8-64 on page 8-47 and
in Figure 8-63 on page 8-47).
Figure 8-63 screw off the 4 screws
Figure 8-64 screw off the 6 screws