GE Voluson i BT06 - How to Activate Screen Lock; How to Adjust LCD Brightness; How to Change the Keyboard Layout

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-101
3-8-1-5 How to activate Screen Lock
Select the
GENERAL page in the System Setup see: Figure 3-122.
1.) Check mark “Screen Lock”.
a.) If no password previously entered, the following dialog appears.
b.) Enter “New Password”.
NOTE: A new screen lock password must be at least 6 characters long and has a maximum length of 80
characters. The password must contain at least 2 non-letter characters, 0...9 or !@#$%^*().
c.) “Retype new Password” and then click SAVE&EXIT
to save new screen lock password.
2.) Click SAVE&EXIT
to save Settings and exit System Setup.
Status of the Screen Lock is shown in the menu area of the “Utilities” menu. I
3-8-1-6 How to adjust LCD Brightness
see: Chapter 6 - LCD Brightness on page 6-3.
3-8-1-7 How to change the Keyboard Layout
see: Chapter 6 - Setup the Voluson i / Voluson e Keyboard Language Layout on page 6-10.
Figure 3-124 Screenlock Password
Figure 3-125 Screen Lock status - shown in “Utilities” menu
NOTICE
!! NOTICE:
The Screen Lock password cannot be reset by the user!
Screen Lock “hooked” in System Setup
to change current Password
only available if “Emergency Mode” is activated