GE Voluson i BT06 - Installation Gel Condom Holder; Probe Holder for Endocavity Probe

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-37
3-5-3-1 Attaching the Voluson i / Voluson e to the Voluson Station (cont’d)
8.) Press the Circuit breaker on the Voluson Station. To start up the system, press the On/Off button
(see: Figure 3-87) on the control panel of the Voluson i / Voluson e system (for ~3 seconds).
3-5-3-2 Installation Gel Condom Holder / Probe Holder for Endocavity Probe
1.) Put the Gel Condom Holder or the Probe Holder for Endocavity Probes into the Holder Adaptation.
Figure 3-40 Peripherals mounted and secured / Power Supply of Voluson Station
Figure 3-41 Installation Gel Condom Holder / Probe Holder for Endocavity Probes
Circuit breaker
on Voluson Station
main power cable
Additional Shelf Peripherals
(e.g., Color printer)
Console Bottom Shelf
(e.g., B&W Printer)
Power Supply