GE Voluson i BT06 - Connecting the Wireless Network Adapter;Interface; Connection Directly to the Voluson I; Voluson E System; Voluson I; Voluson E Mounted on Dock Cart; Voluson I; Voluson E Mounted on Voluson Station

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-43
3-5-4 Connecting the Wireless Network Adapter/Interface
3-5-4-1 Connection directly to the Voluson i / Voluson e system
The Wireless Network adapter should be connected to the PCMCIA slot at the rear of the Voluson i /
Voluson e.
The Wireless Network Interface should be connected to the USB-Ports at the rear of the Voluson i /
Voluson e.
NOTE: You only can use the Network Adapter or the the Network Interface.
1.) Power off/Shutdown the system as described in: Section 3-6-3 on page 3-72.
2.) Insert the Wireless Client Network adapter into the PCMCIA slot or the Wireless Network Interface
into the USB-Port at the rear of the Voluson i / Voluson e.
All software drivers are pre-installed for the designated Wireless Network adapter only.
3.) Turn ON the power of the system and wait till the system has booted.
NOTE: After physical connection of the WLAN adapter/WLAN Interface to the Voluson i / Voluson e system,
follow the procedure described in Section 3-11-1-7 "Wireless Network Configuration" on page 3-110.
3-5-4-2 Voluson i / Voluson e mounted on Modo Cart
The Wireless Network adapter should be connected to the PCMCIA slot at the rear of the Voluson i /
Voluson e. Whenever moving the system with the Wireless Network adapter installed, make sure you
do not damage the adapter.
3-5-4-3 Voluson i / Voluson e mounted on Dock Cart
The Wireless Network adapter should be connected to the PCMCIA slot at the rear of the Voluson i /
Voluson e. Whenever moving the system with the Wireless Network adapter installed, make sure you
do not damage the adapter.
3-5-4-4 Voluson i / Voluson e mounted on Voluson Station
The Wireless Network adapter should be connected to the PCMCIA slot at the rear of the Voluson i /
Voluson e. Whenever moving the system with the Wireless Network adapter installed, make sure you
do not damage the adapter.
The Wireless Network Interface should be connected to the USB ports in the middle of the Voluson
Station.
Figure 3-55 Connection Scheme - Wireless CardBus Network Adapter / Wireless Network Interface
This side up!
Eject button
PCMCIA slot