GE Voluson i BT06 - GE VOLUSON I; Direction Kti106052, Revision

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-90 Section 3-7 - Printer Installation
3-7-4 Printer Installation manually (cont’d)
15.)The “Complete the Add Printer Wizard” window appears on the screen.
16.)Complete the manual Printer Installation with the FINISH
button.
NOTE: If the message “The software you are installing for this hardware has not passed Windows ....” appears,
click CONTINUE ANYWAY
.
17.)Close all open windows, close the “System Setup” with SAVE & EXIT
and restart the system
(turn off and on the system).
Figure 3-112 Complete manual Printer Installation
NOTICE
!! NOTICE:
After boot up of the system, verify the correct settings in the printer “Properties”, see: Section 3-7-5
"Adjustment of Printer Settings" on page 3-91.