GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 10 - Care & Maintenance 10-7
10-5-2-2 Peripheral/Option Checks
If any peripherals or options are not part of the system configuration, the check can be omitted.
Refer to Table 3-13, “Approved Peripherals,” on page 3-103 for a list of approved peripherals.
10-5-2-3 Mains Cable Inspection
10-5-2-4 Optional Diagnostic Checks
Optionally you can access the diagnostic software as described in Chapter 5 or 7.
View the error logs and run desired diagnostics.
Table 10-6 Approved Peripheral/Hardware Option Functional Checks
Step Item Description
1 B/W Printer
Verify hardcopy output of the B/W video page printer. Clean heads and covers if necessary.
2 Color Printer
Verify hardcopy output of the Color video page printer. Clean heads and covers if necessary.
3
Color Deskjet
(Bluetooth) Printer
Verify hardcopy output of the Deskjet (Bluetooth) printer. Clean heads and covers if necessary.
4 VCR
Verify record/playback capabilities of the VCR. Clean heads and covers if necessary.
5 DVD Recorder
Verify record/playback capabilities of the DVD recorder. Clean heads and covers if necessary.
6
DICOM®
Verify that DICOM® is functioning properly. Send an image to a DICOM® device.
7DVD-Drive
Verify that the DVD-drive reads/writes properly
(export/recall images in Sonoview).
Table 10-7 Mains Cable Inspection
Step Item Description
1 Unplug Cord
Disconnect the main cable from the wall and system.
2 Inspect
Inspect it and its connectors for damage of any kind.
3Verify
Verify that the LINE, NEUTRAL and GROUND wires are properly attached to the terminals, and that
no strands may cause a short circuit.
4 Verify
Inlet connector retainer is functional.
To Next Page
Loading...
