GE Voluson i BT06 - B&W Printer P95; Color Printer CP30; Mitsubishi Printer Settings

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 3 - Setup Instructions 3-95
3-7-5-3 Mitsubishi Printer Settings
3-7-5-3-1 Color Printer CP30
1.) Call up the ‘Printer Preferences’; operation see: Section 3-7-5 "Adjustment of Printer Settings" .
2.) Select the PAPER
page and select:
- Paper Size: L (large)
- Orientation: Landscape (recommended when using large paper size)
3.) For saving the adjusted printer settings click APPLY
and then OK. Finally close the "Printer
Preferences" window with the close button and exit System Setup with SAVE&EXIT
.
3-7-5-3-2 B&W Printer P95
1.) Printer Settings directly on the B&W Printer:
a.) Press the "BRT" button on the printer and adjust Brightness to "0" by using the turning knob.
b.) Press the "CONT" button on the printer and adjust Contrast to "0" by using the turning knob.
c.) Press the "SHARP" button on the printer and adjust Sharpness to "3" by using the turning knob
d.) Press the "FUNC" button on the printer and adjust Gamma to "r5" by using the turning knob.
For saving and exit press the "BRT" button twice.
If necessary remove the CD and restart the system (turn off and on the system).
Figure 3-118 Paper page
Figure 3-119 Printer Settings - B&W Printer
Brightness: 0
Sharpness: 3
Contrast: 0
Gamma: 5