GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-42 Section 3-5 - Connection of Auxiliary Devices
3-5-3-9 Mounting large Peripherals (e.g., VCR)
1.) Screw out the screws of the leveling feet from the VCR.
2.) Mount the adapter board with the 4 screws on the VCR (leveling feet are also mounted).
NOTE: Pay attention to the right mounting position of the printer.
3.) Put the pre-assembled VCR on the Additional Shelf Peripherals.
4.) Place the locking teeth of the adapter board into the guide slots of the shelf and move the VCR in
the final mounting position.
5.) Mount the adapter board with 1 screw on the Additional Shelf Peripherals (see Figure 3-53, above).
6.) Connect the peripheral device and mount the pull out protection of the power cable.
Links to connection schemes can be found in Table 3-9, “Connection Procedures,” on page 3-23.
Figure 3-52 mount the adapter board
Figure 3-53 put the pre-assembled VCR on the Shelf / mount the adapter board
Figure 3-54 Connect peripheral device to the Voluson Station
Connect B/W printer
or Color printer
Connect Power
Distribution
To Next Page
Loading...
