GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
8-50 Section 8-19 - Replacement of the Dock Cart Components
8-19-6 Replacement of the Front Column Cover
8-19-6-1 Manpower
One person, 20 minutes
8-19-6-2 Tools
Phillips screwdriver 1
8-19-6-3 Preparation
1.) Remove the Tray upper as described in Section 8-19-2 on page 8-46.
2.) Remove the Tray lower as described in Section 8-19-3 on page 8-47.
3.) Remove the Cover Bottom as described in Section 8-19-4 on page 8-48.
4.) Remove the Back Column Cover as described in Section 8-19-5 on page 8-49.
8-19-6-4 Front Column Cover - Removal Procedure
1.) Screw off the 4 screws of the white part and carefully remove them.
2.) Screw off the 2 screws in the front of the gray part and carefully remove them.
8-19-6-5 Front Column Cover - Installation Procedure
1.) Place the new Front Column Cover and fasten it with the screws.
2.) Mount the Back Column Cover as described in Section 8-19-5-5 on page 8-49.
3.) Mount the Cover Bottom as descirbed in Section 8-19-4-5 on page 8-48.
4.) Mount the Tray lower as described in Section 8-19-3-5 on page 8-47.
5.) Mount the Tray upper as described in Section 8-19-2-5 on page 8-46.
Figure 8-68 screw off the screws
To Next Page
Loading...
