GE Voluson i BT06 - Page 132

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-62 Section 3-5 - Connection of Auxiliary Devices
3-5-14-1 Direct Connection to the Voluson i / Voluson e system (cont’d)
NOTE: Dip switches are located beneath the video converter, as shown in Figure 3-76 below.
5.) If not already done, set the switches to the correct positions, as shown in Figure 3-77 below.
6.) When all power and signal cables are connected to the system, DVD recorder and video converter,
proceed as follows (in the order stated):
a.) Press the power ON switch on the DVD recorder.
b.) Press the power ON switch on the Video converter.
c.) Turn ON power to the Voluson i / Voluson e system.
7.) Press the Input Select button (see Figure 3-76 on page 3-62) on the video converter three times
in order to select RGB Input as your signal source.
The LED located on the video converter front panel will be illuminated, accordingly.
8.) Adjust the DVD Recorder settings as described in Section 3-5-14-5 on page 3-65.
NOTE: If the VGA cable is disconnected/reconnected while the system is ON, the VGA output is maintained.
NOTE: If system is shut-down to standby or Full-shut-down while the VGA device is connected continuously,
the VGA output will appear after the system is turned ON.
NOTE: If the system is shut-down to Standby or Full-shut-down and the VGA device is disconnected, the VGA
output will not appear after power is turned ON, and the above procedure will have to be repeated.
Figure 3-76 Video Converter Ophit (left image)/Video Converter Canopus (right image)
Figure 3-77 Video Converter Dip Switch Positions
Dip Switches
Power On/Off button
Video Scan Converter Ophit
Dip Switches
Input Select button
Video Scan Converter Canopus
Dip-Switch Settings NTSC: 5 off
Dip-Switch Settings PAL: 5 on
Model Ophit
Model Canopus