GE Voluson i BT06 - Page 136

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-66 Section 3-5 - Connection of Auxiliary Devices
3-5-14-5 Adjustment of the DVD Recorder Settings (cont’d)
6.) Press the ↓
(down) button repeatedly, until [MENU GRADE] is highlighted.
7.) Press the →
(right) button and select [ENHANCED].
8.) Press the ←
(left) button, to exit the “Menu Grade” menu.
NOTE: Now additional items (see: Figure 3-82 below) are displayed in the “Setup Menu” .
9.) Select [TV SYSTEM] by pressing the ↓
(down) button.
10.)Press the →
(right) button. The “TV System” Sub menu appears.
11.)Select the appropriate video signal by pressing the ↑
(up) or ↓ (down) button respectively.
To check the video signal, see: Table 3-10, “TV-System and Region Code,” on page 3-67.
12.)Press the SET
button (C).
The message “Now loading...” appears and the unit starts to save the settings.
13.)When “Power off” appears on the display, press the POWER
switch on the front of the DVD
recorder to turn power off.
14.)Press the POWER
switch again to turn power on.
Figure 3-81 “Setup Menu” - [MENU GRADE] highlighted
Figure 3-82 “Setup Menu” - [TV SYSTEM] highlighted
Menu Grade: ENHANCED
TV SYSTEM
REGION CODE