GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
3-82 Section 3-7 - Printer Installation
3-7-1-1 Install the UP-D897 printer software/driver (cont’d)
NOTE: If path (R:\system\....) is different from what is shown in Figure 3-98, click on the BROWSE
button to
search correct driver.
5.) Confirm the correct path and click NEXT
to install the driver. All necessary files are copied.
6.) If the following Warning message appears, click CONTINUE ANYWAY
.
7.) Confirm the installation by clicking FINISH
to close the Hardware Wizard.
8.) Close all open windows and restart the system (turn off and on the system).
Figure 3-98 Search for Network path
Figure 3-99 Finish installation
!! NOTICE:
After boot up of the system, verify the correct settings in the printer “Properties”, see: Section 3-7-5
"Adjustment of Printer Settings" on page 3-91.
verify correct path, otherwise [Browse] for
R:\system\periph\SonyUP-D897
R:\system\periph\SonyUP-D897
To Next Page
Loading...
