GE Voluson i BT06 - Page 245

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 5 - Components and Functions (Theory) 5-13
5-2-5 Description of Software Options (cont’d)
NOTE: Additional options are not yet implemented in the Voluson i / Voluson e.
Table 5-3 Software Options at Voluson e
SW-Option at Voluson e Description
1
DICOM
® 3 (Interface for DICOM® 3 Standard)
DICOM®
2
4D Basic (4D rendering only!)
Real Time 4D
(4D rendering only, no 3D Mode and no access to volume data)
3
3D/4D Advanced (3D Mode and Real Time 4D).
3D Mode
Real Time 4D
Note:
The option “3D/4D Advanced” is only available if the option “4D
Basic” is also enabled.
4
RIC Probe
Note: The Real time 4D endocavity probe (RIC5-9RS) is only
applicable if this option is enabled.
5
RO Note: The RAB-Probes are only applicable if this option is enabled.
6
XTD-View XTD-View (Extended View)
7
SonoVCAD labor SonoVCAD labor
8
SonoAVC SonoAVC - Sono Automated Volume Count
9
SonoNT SonoNT
10
SonoRS Sono Render Start
BT Version:
BT-Version:
The options “SonoVCAD labor” and “SonoAVC” are only applicable at Voluson i / Voluson e systems
with BT´09 software.
BT Version:
BT-Version:
The options “SonoNT” and “SonoRS” are only applicable at Voluson e systems with BT’11 software.