GE Voluson i BT06 - Page 303

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 6 - Service Adjustments 6-11
Section 6-9 Modification of Keyboard Layout (cont’d)
6.) Select the default input language from the drop down menu.
NOTE: If the desired language is not listed, click the ADD
button, choose the desired input language from the
drop down menu, as shown in Figure 6-14 below, and then confirm with OK
.
(The corresponding keyboard layout is shown automatically.).
7.) If not already done, select the default input language from the drop down menu (see: Figure 6-13).
The corresponding keyboard layout is changed automatically.
8.) Click on APPLY
and then close the window with OK.
9.) Close the Service page with the SAVE&EXIT
button and restart the system.
10.)Reenter “Keyboard Layout” by repeating step 1.) to step 6.). This time remove unused language(s).
11.)Test the Keyboard function after Restart:
- Press the TEXT
key (upper row of the alphanumeric keyboard).
- Press some keys on the keyboard and verify the entered text.
Figure 6-13 Default input language
Figure 6-14 Default Keyboard Settings and Input Locale Properties
default input language
[Add] button
corresponding
keyboard layout
(drop down menu)
[Remove] button
to remove unused
language(s)
corresponding keyboard layout
default input language
(drop down menu)