GE Voluson i BT06 - Section 7-9 Error Messages

GE VOLUSON i / VOLUSON e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 7 - Diagnostics/Troubleshooting 7-27
Section 7-9
Error Messages
NOTICE
If the problem (error message) still exists after performing the described actions, call technical support.
Error Messages Actions
AcousticUnitType not supported by BF_Interface: restart the system
AcquMode - incorrect BBC_Wnd pointer restart the system
Array bounds exceeded restart the system
Attempt to read Probe-ID from an invalid probe connector. restart the system.
AVI Save function fails check the Power cable - restart the machine and try again
B_Enhance Out Of Range press ok and save this user-setting once again
B_Gain Out Of Range press ok and save this user-setting once again
B_Reject Out Of Range press ok and save this user-setting once again
B_TxFocus - not calculated and B_SHOT_PART_ON restart the system
BBC_Acquisition Wnd - block creation failed restart the system
BBC_Acquisition Wnd - incorrect ReplayCtrl-object restart the system
BBC_Archive Wnd - incorrect ReplayCtrl-object restart the system.
Backup error while writing. (Error during writing of backup data.)
check storage destination for Full Backup
(e.g., DVD/CD not empty, insufficient rights on target
Network drive, write protection on USB-drive)
Backup error while verifying. (Checksum mismatch) repeat backup
BC Ensemble Out Of Range press ok and save this user-setting once again
BC lines_per_sequenz < 1 restart the system
BC lines_per_sequenz < 2 restart the system
BC_Dynamic Out Of Range press ok and save this user-setting once again
BC_Gain Out Of Range press ok and save this user-setting once again
BC_Lines: BC_LineDensity out of limit restart the system
BCMC_Balance Out Of Range press ok and save this user-setting once again
bCP_ConvertParameters failed restart the system
bCP_ProcessIQEnsemblePacket failed restart the system
bCP_ProcessIQMModePacket failed restart the system
B-DynContrast Out Of Range press ok and save this user-setting once again
BF: can't set BM RxApod restart the system