GE VOLUSON
i / VOLUSON
e
D
IRECTION KTI106052, REVISION 10 SERVICE MANUAL
Chapter 8 - Replacement Procedures 8-87
8-20-26 Replacement of the DVD Drive
8-20-26-1 Manpower
One person, 10 minutes
8-20-26-2 Tools
Phillips screwdriver 1
8-20-26-3 Preparations
1.) Power Off/Shutdown the system as described in Section 3-6-3 on page 3-72.
2.) Remove the Top Shelf Additional Bottom Cover as described in Section 8-20-12 on page 8-72 or
remove the optional Probe Mux Bos as described in Section 8-20-9 on page 8-68.
3.) Remove the Top Shelf Bottom Front Cover as described in Section 8-20-19 on page 8-80.
8-20-26-4 DVD Drive - Removal Procedure
1.) Unplug the USB-cable and the Power-cable.
2.) Loosen the 4 screws (2 on each side) and remove the DVD drive.
8-20-26-5 DVD Drive - Installation Procedure
1.) Place the new DVD Drive and fasten it with the 4 screws (2 on each side).
2.) Reconnect the cables.
3.) Mount the Top Shelf Bottom Front Cover as described in Section 8-20-19-5 on page 8-80.
4.) Mount the Top Shelf Additional Bottom Cover as described in Section 8-20-12-5 on page 8-72 or
mount the optional Probe Mux Box as described in Section 8-20-9-5 on page 8-69.
Figure 8-109 unscrew the screws
2 on each side
2 on each side
To Next Page
Loading...
