GRAPHTEC CE6000-120AP - Setting Paper Ready Time

4-8
Supplement
You can set between 0 and 5.
Cutting/plotting will begin immediately after
the pre feed is complete and data sent
during paper exposure time is received.
5 Press the POSITION ( ) keys to change the current setting.
Supplement
It will return to MEDIA SETTING screen
without changing the settings when you press
the POSITION (
) key (CANCEL).
6 Confirm the setting and press the [ENTER] key (SET)
Setting will be set, and it will return to MEDIA SETTING screen (1/2).
7 Press the [PAUSE/MENU] key.
It will return to default screen.
Setting paper Ready time
This function sets the time the paper/media is acclimated to the operating environment after being pulled off the
paper roll to minimize media expansion or contraction, and prevent it from adversely effecting cutting or plotting.
After the initial feed is complete, the paper will be fed backwards to half the preset feed length and exposed for
the set amount of time.
This function is available when the Initial Feed or if Panel Cutting is ON.
Operation
Supplement
Perform the settings in Normal menu.
For the READY status, see "How to Use
Control Panel"
P. 2-21
.
1 Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2 Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3 Press the POSITION ( ) key.
MEDIA SETTING screen (3/3) is displayed.