GRAPHTEC CE6000-120AP - 2.10 Selecting Tool Condition

2-29
Tool condition can remember up to 8 settings.
Changing these settings allows you to make the proper settings for each different type of media.
Selecting Tool Condition
Condition No.1 applies specifically to use of the pen plunger for the either oil-based ballpoint pen or water based
fiber-tip pen.
Condition No.2 to No.8 applies specifically to the use of the cutter plunger.
Operation
Supplement
CONDITION No. can also be changed from
READY status. See "Changing CONDITION
No."
P. 3- 6
.
1 Press the [COND/TEST] key in the default screen.
CONDITION setting screen (1/3) is displayed.
2 Press the [1] key (Condition No.).
CONDITION No. selection screen is displayed.
Supplement
It will return to CONDITION screen without
changing the settings when you press the
POSITION (
) key (CANCEL) .
3 Press the POSITION ( ) key and select the setting
(CONDITION No.).
4 Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to CONDITION screen (1/3)
5 Press the [COND/TEST] key.
It will return to default screen.
2.10
Selecting Tool Condition