2-46
2.13.2 Setting the number of pre feeds (Simple menu)
Set the number of pre feeds to prevent deviations from occurring when the roll media is pulled out. During
the pre feed, the grit roller leaves traces on the paper. Pre feeds can be repeated after paper exposure time
has elapsed (see "Setting paper Ready time"
P.4 - 8
). This function is available when the Initial Feed or if
Partition Pastern are activated, and can be set under the "normal" menu.
This setting is enabled only when the initial feed setting is “On”, or the partition pastern is “On”.
You can also be set it on the Normal menu.
Operation
1 Press [PAUSE/MENU] key.
MENU screen is displayed.
2 Press [1] key (MEDIA).
MEDIA SETTING screen is displayed.
3 Press [3] key (PAPER LOAD FUNCTION).
PAPER LOAD FUNCTION setting screen is displayed.
Supplement
You can set between 0 and 5.
Cutting/plotting will begin immediately after
the pre feed is complete and data sent
during paper exposure time is received.
4 Press the POSITION ( ) keys to change the current setting.
Supplement
Press the POSITION ( ) (CANCEL) key to
return to the MEDIA SETTING screen without
changing any settings.
5 Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA SETTING screen.
6 Press [PAUSE/MENU] key.
It will return to default screen.
To Next Page
Loading...
