2-4
2.2
Attaching a Tool
Attach a tool (cutter plunger, plotter pen) to the plotter.
Attaching a cutter plunger
When mounting the cutter plunger in the tool holder, please note the following.
•
Push the cutter plunger all the way into the holder until its flange contacts the upper part of the cutter holder
and then tighten the screw firmly.
•
To prevent injury; avoid absolutely touching the cutter plunger immediately after the cutting plotter is turned on
or whenever the cutter plunger is moving.
The cutter holder is suitable only for use with the cutter plunger. Please refrain from attaching the plotting pen to it.
Pen holder
Bracket to hold tool
Top
This cutter holder is
not set backward.
Cutter holder
(Forward)
CAUTION
When pushing the cutter holder with your fingers, the blade tip may be protruding. Take care not to cut your fingers.
Supplement
Please make certain to set the cutter plunger of the cutter holder (forward).
Mounting
1 Loosen the cutter holder screw.
Pen holder
Bracket to hold tool
Bracket to hold tool
Cutter holder
Top
To Next Page
Loading...
