GRAPHTEC CE6000-120AP - Setting of Step Movement Distance

3-4
Setting of Step Movement Distance
The parameters when setting the cutting direction are determined by the distance of the cutting direction.
Operation
Supplement
Perform the settings in Normal menu.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the POSITION ( ) key (ADV).
ADV. setting screen (1/2) is displayed.
3 Press the [1] key (MOVE STEP).
MOVE STEP screen is displayed.
Supplement
Value chosen here will be the movement
distance for the step movement.
4 Press the [1] key (1.0mm) or the [2] key (0.1mm).
Supplement
It will return to DEFAULT setting screen (1/2)
without changing the settings when you press
the POSITION (
) key (CANCEL).
5 Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to DEFAULT setting screen (1/2).
6 Press the [PAUSE/MENU] key.
It will return to default screen.