GRAPHTEC CE6000-120AP - Chapter 2: Preparing to Cut

2-1
Chapter 2: Preparing to Cut
This chapter describes how to prepare to start the cutting.
PRODUCT SUMMARY
2.1 Preparation of Cutter Plunger
2.2 Attaching a Tool
2.3 Loading Media (Paper)
2.4 Aligning the Push Rollers
2.5 About the Default Screen
2.6 Connecting to the Power
2.7 How to Use Control Panel
2.8 Setting Feeding Method
2.9 Auto media transfer and cross cut
2.10 Selecting Tool Condition
2.11 Setting Cut Line Pattern
2.12 Running Cutting Tests
2.13 About Simple menu
2.13.1 Setting Page Length (Simple mode)
2.13.2 Setting the number of pre feeds (Simple menu)
2.13.3 User selection settings (Simple menu)
2.13.4 Setting RS-232C interface (Simple menu)
2.13.5 Display Length Unit Settings (Length Unit) (Simple menu)
www.delinit.by