2-26
Feeding method for the loaded media is set.
Operation
CAUTION
Before doing the media set selection, make sure
to release the media lock.
Supplement
The CONTINUE menu parameter appears
when the media set lever is raised and then
lowered again after media was previously
loaded, making it possible to select the
previous settings.
Pressing the [4] key to Continue (Do
the same thing as last time)
When using the same media without changing
the position of the media, the CONTINUE
function enables the continued use of the
plotting area, pen position and origin position
that were specified before the media set lever
was lowered. If the current media is the same
size as the last media that was loaded, the
plotter does not detect the media's edges.
1 If you have already loaded the media, the MEDIA TYPE
menu appears. Select the media type to suit the loaded
media.
Check that the media stopper is unlocked and then select a
media type on the media set setting screen.
Lever
Lowering the lever releases the stopper lock.
Supplement
When selecting [1] or [2] key
Please confirm on the confirmation screen that
the lever lock has been released, then press
the [ENTER] key. This will be displayed on the
above screen.
When selecting [3] key
The above screen will display when set-up
for media more than 5 meters long. Please
confirm and then press the [ENTER] key To
cancel, please lower the media set level and
change the media.
When Selecting [ROLL-1
FRONT EDGE] Pressing the [1] Key
Select this when you have loaded a roll of media and you
wish to start cutting or plotting from the leading edge.
The width and leading edge of the roll media are detected.
When Selecting [ROLL-2
CURRENT POSITION] Pressing the [2] Key
Select this when you have loaded a roll of media and you
wish to start cutting or plotting from a point beyond the
leading edge.
Only the width of the roll media is detected.
When pressing the [3] key to select SHEET
Select this when a cut sheet has been loaded. The width,
leading edge, and trailing edge of the sheet are detected.
2.8
Setting Feeding Method
To Next Page
Loading...
