2-27
2 When selecting [1] or [2] key, the following screen is
displayed.
Please confirm that the stock shaft lock has been released,
then press the [ENTER] key.
When [3] key is selected to set-up media more than 5 meters
long, the following screen is displayed.
Please confirm, then press the [ENTER] key. To cancel,
please lower the set level and change the media.
Supplement
The screen below shows a machine currently
detecting media.
3 After the media is detected, the plotter is ready to receive
data for cutting or plotting. This status is called "READY
status" of the default screen.
When setting is finished, the tool carriage's location will
become the initial point.
If the interface or command settings have not been made,
make these settings before sending the data.
If the settings have been made, tool adjustment is performed.
When the pen adjustments have been made, the plotter is
ready to start cutting.
Send the cutting or plotting data from the application
software.
Dfault screen is displayed.
To Next Page
Loading...
