GRAPHTEC CE6000-120AP - Other Error Messages

12-10
Other Error Messages
Symptom LCD Display Possible Cause Solution
E01001
to E01005
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01006
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01007
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01008 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01009
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01010
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01011 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01012
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01013 The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01014
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01015
The plotter is defective. Contact your sales representative or the
Graphtec call center.
E01017
The plotter is defective.
Load on the motor was too large.
Move the object disturbing the operation,
and turn on the plotter after turning it off
once.
Do not use heavy media.