GRAPHTEC CE6000-120AP - Blade Wear Detect

6-16
BLADE WEAR DETECT
This setting will detect the blade wear when Blade Wear Setup is ON and will not do so when OFF.
Operation
Supplement
Perform the settings in Normal menu.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press [1] key (TOOL).
TOOL SETTING screen (1/3) is displayed.
3 Press [2] key (BLADE WEAR SETUP).
BLADE WEAR SETUP screen is displayed.
4 Press [1] key (BLADE WEAR DETECT.).
BLADE WEAR DETECT screen is displayed.
Supplement
Press [2] key to clear the blade wear.
5 Press the [1] key (ON) or the [2] key (OFF).
Supplement
It will return to BLADE WEAR SETUP screen
without changing the settings when you press
the POSITION (
) key (CANCEL).
6 Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to BLADE WEAR SETUP screen.
7 Press the [PAUSE/MENU] key.
It will return to default screen.