6-4
Setting Length of the Overcut
Set the length of overcut with tangential mode.
Operation
Supplement
Condition No.1 is pen specific. When setting
up tool conditions for the cutter plunger, please
choose from Condition No.2 to Condition
No.8 under "Selecting the Tool Condition". For
more information, see "2.10 Selecting Tool
Condition"
P. 2-2 9
.
1 Press the [COND/TEST] key.
CONDITION setting screen (1/3) is displayed.
2 Press the POSITION ( ) key.
CONDITION setting screen (2/3) is displayed.
3 Press the [4] key (OVERCUT).
OVERCUT setting screen is displayed.
4 Press the [1] key (Condition No.)
CONDITION No. selection screen is displayed.
5 Press the POSITION ( ) key and select the CONDITION
No.
6 Confirm the setting, and press the POSITION ( ) key
(PREVIOUS).
Condition No. is selected and return to OVERCUT setting screen.
To Next Page
Loading...
