GRAPHTEC CE6000-120AP - Setting the Space Rear

4-9
4 Press the [2] key (PAPER READY TIME).
PAPER REDY TIME setting screen is displayed.
Supplement
Paper exposure time can be set to 0, 60, 120,
180, 300, 420, or 600 seconds.
5 Press the POSITION ( ) key and increase or decrease the
setting value.
Supplement
Press the POSITION ( ) (CANCEL) key to
return to the MEDIA SETTING screen (3/3)
without changing any settings.
6 Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to MEDIA SETTING screen (3/3).
7 Press the [PAUSE/MENU] key.
It will return to default screen.
Setting the space rear
This setting allows a cross cut to be made from the maximum value of the cut along the X axis based on the rear
margin setting during time out or when making a cross cut across a separator.
Operation
Supplement
Perform the settings in Normal menu.
For the READY status, see "How to Use
Control Panel"
P. 2-21
.
1 Press the [PAUSE/MENU] key in READY status.
MENU screen is displayed.
2 Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3 Press the POSITION ( ) key.
MEDIA SETTING screen (3/3) is displayed.