6-24
11 Press [2] key (X=+0.0mm).
Adjust the space between tools 1 and 2 (X) setting screen is displayed.
Supplement
You can set between -3.0mm and +3.0mm.
12 Press POSITION ( ) keys to increase or decrease the
parameters.
13 Confirm the settings and press the POSITION ( ) key
(PREVIOUS).
Adjust the space between tools 1 and 2 (X) setting screen is displayed.
14 Press [3] key (Y=+0.0mm).
Adjust the space between tools 1 and 2 (X) setting screen is displayed.
Supplement
You can set between -3.0mm and +3.0mm.
15 Press POSITION ( ) keys to increase or decrease the
parameters.
16 Confirm the settings and press the POSITION ( ) key
(PREVIOUS).
Adjust the space between tools 1 and 2 (X) setting screen is displayed.
17 Repeat steps 7 through 16 until there is no longer a gap
between the two tools.
Supplement
It will return to TOOLS SETTING screen (3/3)
without changing the settings when you press
the POSITION (
) key (CANCEL).
18 Confirm the space and press the [ENTER] key (SET).
Setting will be set, and it will return to TOOL SETTING screen (3/3).
19 Press the [PAUSE/MENU] key.
It will return to default screen.
To Next Page
Loading...
