GRAPHTEC CE6000-120AP - 4.5 Setting a cut (F_CUT) for F command

4-19
4.5
Setting a cut (F_CUT) for F command
When using the GP-GL command, using the feed command, you can set whether performing cross cut or not.
In this function, even if the parameter that do not cut the media with the feed command is sent, the cross cut will
be performed.
Reference
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal menu.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3 Press [2] key ('F' COMMAND CUT).
'F' COMMAND CUT screen is displayed.
4 Press [1] key (ON) or [2] key (OFF).
Supplement
It will return to MEDIA SETTING screen (1/3)
without changing the settings when you press
the POSITION (
) key (CANCEL).
5 Confirm the setting and press the [ENTER] key (SET).
Confirm the settings and return to the MEDIA SETTING screen (1/3).
6 Press the [PAUSE/MENU] key.
It will return to default screen.