2-5
Supplement
Set the tool in the cutter holder (forward).
2 While pushing up the cutter holder, push until its flange
completely touches the upper part of the cutter holder.
Flange
Bracket to hold tool
This cutter holder is
not set backward.
Cutter holder
(Forward)
Flange
3 Make sure that the tool bracket is engaged on the cutter
plunger's flange, and then tighten the screw.
Flange
Bracket to hold tool
Removing the cutter plunger
When removing the cutter plunger, turn it counterclockwise to remove the cutter plunger.
To Next Page
Loading...
