8-8
Regarding the separator settings, the command that is set as separator is judged as the data juncture when it is
sent. All data up to that juncture will be plotted, after which cross cutting will be performed.
GP-GL Separator
Set the separator when using GP-GL.
Reference
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal menu.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the POSITION ( ) key (I/F).
INTERFACE setting screen (1/3) is displayed.
3 Press the POSITION ( ) key.
INTERFACE setting screen (2/3) is displayed.
4 Press [3] key (GP-GL SEPARATOR).
GP-GL SEPARATOR screen is displayed.
Supplement
You can set "FS", "H", "J0", "F", or "−".
5 Press the POSITION ( ) keys to change the current setting.
8.2
Setting a separator
To Next Page
Loading...
