2-18
Changing the Hold-down Force
The down force applied by the middle 3 push rollers can be changed depending on the width and type of media
used.
When using the genuine Graphtec paper, please set the force of the middle push roller to "Normal" and the
remaining 2 rollers to "Low" (OFF).
Media sensor
Grit roller
Push roller
Left-hand push roller
Right-hand push roller
Normal
Low (OFF)
Low (OFF)
Switching
(1) Lower the media set lever to raise the push rollers.
(2) Use the push roller hold-down force switching lever on the back of the push roller to adjust the center push
roller's hold-down force. It can be set to Normal or Low (OFF).
(3) When the push roller hold-down force switching lever is up, it is in Normal mode. When it is down, it's Low
(OFF).
Hold-down force: Normal Hold-down force: Low (OFF)
Lever Lever
CAUTION
Hold-down force can not be switched for side push rollers.
Supplement
Switch the hold-down force as necessary for different types of media.
To Next Page
Loading...
