GRAPHTEC CE6000-120AP - 2.7 How to Use Control Panel

2-21
This section explains the function of lamps and keys on the control panel.
[1] key [SIMPLE] lamp [SIMPLE] key [MENU] lamp
[ORIGIN] key
[2] key [PAUSE/MENU] key
[4] key[3] keyScreen (LCD) [FAST] key POSITION (
) key [COND/TEST] key
[COPY] key
[ENTER] key
Control Keys
POSITION ( ) key
............................ There are following functions depending on the operation.
Move the tool carriage and media. It will move specified distance (see "Setting of Step
Movement Distance"
P. 3 - 4
) when it is pressed once, and continuously move when
it is pressed down. It will select the menu when
are displayed in the menu on the
screen.
FAST .......................... The tool carriage or the media will move faster when it is pressed simultaneously with
POSITION key.
It will work as a menu key when it is displaying "FAST" on the screen. Press the [FAST]
key during READY status to display the current area and tool carriage position.
ORIGIN ...................... It will set the current position as an origin point.
On the default screen, pressing the [ENTER] and [ORIGIN] keys at the same time will
allow you to reset the machine. (Only in Normal menu)
COPY ......................... Copy of data in the buffer memory is output.
Menu Keys
SIMPLE ...................... The switch between Simple menu and Normal menu can be performed on the default
screen.
PAUSE /MENU ........... It will switch to the MENU mode. MENU lamp is lit in the MENU mode.
It will go into MENU mode if it is pressed once, and MENU mode will be turned off when
it is pressed again.
Different function are set in the MENU mode.
Data received while in the MENU mode will be stored in the data buffer.
COND/TEST .............. It will display the screen to set the tool conditions.
Use this when checking tool conditions to activate a cutting test.
1, 2, 3, 4 ...................... Select the menu number displayed in the screen.
ENTER ....................... It will define the settings.
Press the [ENTER] and [ORIGIN] keys simultaneously on the default screen to reset the
machine.
2.7
How to Use Control Panel