6-1
Chapter 6:
Setting Regarding Cutting Quality
When actually plotting (cutting), there may be situations where it's not possible to plot (cut) ideally, or where lines
are slightly off, corners are deformed, or uncut paper remains as a result of the characteristics of the media (its
thickness or hardness) or the condition of the blade. Adjust the movement speed and the pressure on the tool and
the control method in order to avoid this problem.
This chapter explains the settings for the quality of these types of plots (cuts).
PRODUCT SUMMARY
6.1 To cut the corner of thick media sharply
6.2 Setting the Step Pass
6.3 Setting the Offset Angle
6.4 Setting the Distance Adjust
6.5 Setting Initial Blade Control Position Adjust
6.6 Settings for OFFSET FORCE
6.7 Blade Wear Detection
6.8 Adjust the space between tools 1 and 2
www.delinit.by
To Next Page
Loading...
