A-2
CE6000-120AP
CPU 32bit CPU
Configuration Grit-rolling plotter
Drive Digital servo
Max. Cut Area 1190 mm × 50 m
Guaranteed precision cutting area*
1
1190 mm × 3 m
Mountable media width*
2
Min: 594 mm
Max: 1220 mm
Diameter of mountable rolls 3-inch paper core
Available roll media diamete Max. diameter: 200 mm
Mountable roll paper (media) 20 kg or less
The number of push roller 5
Max. cutting speed 600 mm/s (Omnidirectiona)
Specifiable speeds (cm/s) 1 to 10, 15, 20, 25, 30, 35, 40,45, 50, 55, 60
(Max. 30 cm/s during PANEL CUTTING)
Cutting Pressure 0.2 to 4.41 N (20 to 450 gf) 38 steps
Min. character size 5 mm alphanumeric Helvetica med. Font
Mechanical resolution 0.005 mm
Program mable resolution GP-GL : 0.1/0.05/0.025/0.01 mm
HP-GL*
4
: 0.025 mm
Repeatable accuracy*
1
*
3
Max. 0.1 mm unit of 2 m (Designated Film and Cut Conditions)
Number of cutters/pens 2
Usable pen type Water-based fiber-tip and oil-based ballpoint
Interface RS-232C/USB2.0 (Full Speed)
Buffer memory 2 MB
Resident command sets GP-GL/HP-GL*
4
(Control panel switching)
LCD display Graphic type (240 × 128 dot)
Power supply AC100-120 V, 200-240 V, 50/60 Hz
Power consumption 120 VA or less
Operating environment 10 to 30℃, 35 to 75 % R.H. (non-condensing)
Guaranteed accuracy environment 18 to 28℃, 40 to 65 % R.H. (non-condensing)
External dimensions (W × D × H) 1575×1200×250 mm (Including stand)
Weight 46 kg (Including stand)
*1: Dependent on the media condition settings specified by this com our company.
*2: Describes the usable paper width. Accuracy assurance for the minimum paper width is the width when the push roller is set to 5 mm
inside of both sides of the media.
*3: Please be aware that the accuracy of this machine is measured against Graphtec Mylar film.
This machine takes only quality coated (glossy) paper
*4: HP-GL is a registered trademark of the US Hewlett Packard Company.
A.1
Main Specifications
To Next Page
Loading...
