4-20
4.6
Setting a force for cross cut
This allows you to adjust the blade force for cross cut.
The setting range for cross cut is between 1 and 38. The larger the set value, the stronger the force.
If the media is thin, set the smaller value and vice versa.
Reference
This setting will be saved even if the power is shut off.
Operation
Supplement
Perform the settings in Normal menu.
1 Press the [PAUSE/MENU] key.
MENU screen is displayed.
2 Press the [4] key (MEDIA).
MEDIA SETTING screen (1/3) is displayed.
3 Press [3] key (CROSS CUT FORCE).
CROSS CUT FORCE screen is displayed.
Supplement
You can set the range between 1 to 38.
4 Press the POSITION ( ) keys to change the current setting.
Supplement
It will return to MEDIA SETTING screen (1/3)
without changing the settings when you press
the POSITION (
) key (CANCEL).
5 Confirm the setting and press the [ENTER] key (SET).
Confirm the settings and return to the MEDIA SETTING screen (1/3).
6 Press the [PAUSE/MENU] key.
It will return to default screen.
To Next Page
Loading...
