GRAPHTEC CE6000-120AP - 12.2 Printing the Setting of the Plotter

12-13
Condition setting list can be printed when you need to check the current setting of the plotter.
CAUTION
Do not place you hand around the moving areas. The tool carriage will start moving, so there is a chance of injury. Tool carriage
will start to move immediately after selecting to print the CONDITION list.
Once you start printing, pause/cancel can not be performed in the middle.
Operation
Supplement
See "Loading Media (Paper)"
P. 2-7
for
loading the media.
1 Set a media larger than A1 size.
Supplement
Please choose Condition No.2 when
selecting the tool conditions for operating
with the pen plunger.
For setting the pen plunger, see "Attaching a
Tool"
P. 2- 4
.
For changing the tool conditions, see
"Selecting Tool Condition"
P. 2-2 9
, and for
tool settings, see "Setting the Tool Condition"
P. 2- 3 0
.
2 Select the pen plunger condition setting and place the pen
plunger in the pen holder.
Supplement
Perform the settings in Normal menu.
3 Press the [PAUSE/MENU] key in the default screen.
MENU screen is displayed.
4 Press the POSITION ( ) key (TEST).
TEST menu screen (1/2) is displayed.
5 Press the [1] key (CONDITION LIST).
CONDITION LIST print screen is displa yed.
12.2
Printing the Setting of the Plotter