GRAPHTEC CE6000-120AP - Page 132

6-13
4 Press the [4] key (INITIAL BLADE).
INITIAL BLADE CONTROL POSITION setting screen is displayed.
5 Press the [1] key (OUTSIDE) or the [2] key (2mm BELOW).
Supplement
It will return to TOOLS SETTING screen (3/3)
without changing the settings when you press
the POSITION (
) key (CANCEL).
6 Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to TOOLS SETTING screen (3/3).
7 Press the [PAUSE/MENU] key.
It will return to default screen.