12-4
Symptom Possible Cause Solution Reference
• It is cutting on the grit roller
imprint.
Cutting width is widened. Please revert the expand limit to the
default setting.
P4-4
Setting Cutting
Width
• Tool condition changes. Setting of the priority is set to
PROGRAM.
Change the setting of the priority to
MANUAL.
P10-3
Priority of
Tool Condition Selection
(CONDITION PRIORITY)
[ENTER] key is not pressed
after changing the TOOL
CONDITION.
Check the TOOL CONDITION again.
P2-30
Setting the Tool
Condition
• Media travels tilted. Media is loaded tilted. Reload the media.
P2-7
Loading Media
(Paper)
Media is slipping. Perform pre feed once and make
impression to make it harder to slip.
P4-7
Setting the
number of pre feeds
Roll media is not set properly. Set the roll media properly.
P. 2-7
Loading Media
(Paper)
Changing of the hold-down
force of the push roller is not
suitable for the media.
Please set a media suitable for
changing the hold-down force.
P2-18
Changing the
Hold-down Force
• It does not become specified
length. (Slight distance
error)
Media is slipping. Make the speed slower.
Increase the tool up speed.
Perform feeding.
P2-30
Setting the Tool
Condition
P4-7
Setting the
number of pre feeds
P7-10
Setting the Tool
Up Speed
Distance adjust value is not
correct.
Perform distance adjust.
P6-10
Setting the
Distance Adjust
• "LOAD MEDIA!" is displayed
even if the media is set and
media set lever is moved up.
Media is close to transparent
and media sensor makes
false recognition. (This may
happen depending on the
media.)
Transparent media cannot be
detected. DISABLE the media sensor
and set the cut area when this kind of
media is used.
P9-4
Enabling/
Disabling the Media
Sensors (MEDIA SENSOR)
P4-2
Setting Cutting
Area
Media sensor malfunctions
with strong scattered
reflection.
Move the position of the light source.
Make is so no direct sunlight shines.
There may be defective in the
operation of the media set
lever sensor.
Contact your sales representative or
the Graphtec call center.
www.delinit.by
To Next Page
Loading...
