GRAPHTEC CE6000-120AP - Page 222

A-12
Menu items Setting items Initial value
ADVANCE MOVE STEP 0.1 mm
LANGUAGE SELECTION Select when initially turning on power
LENGTH UNIT Select when initially turning on power
MEDIA SENSOR ENABLED
PUSH ROLLER SENSOR ENABLED
FAN POWER NORMAL
BEEP FOR KEY OPE. ON
TEST NO SETTINGS –
TOOL
SETTING
CONDITION NO. 1 TOOL CONDITION NO. CONDITION NO. 1
TOOL PEN
SPEED 30
FORCE 12
ACCELERATION 2
CUT LINE PATTERN OFF
TANGENTIAL MODE OFF
OVERCUT (START) 0.000
OVERCUT (END) 0.000
DISTANCE ADJUST OFF
INITIAL DOWN FORCE 0
SET BLADE GROUP 1
SET FACTOR 1.0
CONDITION NO. 2 TOOL CONDITION NO. CONDITION NO. 2
TOOL CB09U
SPEED/FORCE/ACCELERATION 30//8/2
CUT LINE PATTERN 5
TANGENTIAL MODE OFF
OVERCUT (START) 0.200
OVERCUT (END) 0.200
DISTANCE ADJUST OFF
INITIAL DOWN FORCE 0
SET BLADE GROUP 2
SET FACTOR 1.0
CONDITION NO. 3 TOOL CONDITION NO. CONDITION NO. 3
TOOL CB09U
SPEED/FORCE/ACCELERATION 30/14/2
CUT LINE PATTERN 3
The range between tangential mode and wear degree (coefficient)is same as Condition 2
CONDITION NO. 4 TOOL CONDITION NO. CONDITION NO. 4
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/6/2
CUT LINE PATTERN 1
The range between tangential mode and wear degree (coefficient)is same as Condition 2
CONDITION NO. 5 TOOL CONDITION NO. CONDITION NO. 5
TOOL CB09U
SPEED/FORCE/ACCELERATION 20/8/2
CUT LINE PATTERN 4
The range between tangential mode and wear degree (coefficient)is same as Condition 2
CONDITION NO. 6 TOOL CONDITION NO. CONDITION NO. 6
TOOL CB15U
SPEED/FORCE/ACCELERATION 30/16/2
CUT LINE PATTERN 3
The range between tangential mode and wear degree (coefficient)is same as Condition 2
CONDITION NO. 7 TOOL CONDITION NO. CONDITION NO. 7
TOOL CB15U
SPEED/FORCE/ACCELERATION 20/12/2
CUT LINE PATTERN 3
The range between tangential mode and wear degree (coefficient)is same as Condition 2
CONDITION NO. 8 TOOL CONDITION NO. CONDITION NO. 8
TOOL CB09U
SPEED/FORCE/ACCELERATION 30/8/2
CUT LINE PATTERN User
The range between tangential mode and wear degree (coefficient)is same as Condition 2
* The initial values of setting items is subject to change.