GRAPHTEC FC8000 Series - Page 108

5-6 5-7
4POINTS
Feed direction of media Feed direction of media
With more registration marks, precision of matching the printed image and the cutting will increase. But if there
are many registration marks, it will take longer to detect, and the area that can be cut becomes smaller.
1 axis adjustment (2POINT detection)
Supplement
Alignment registration mark cannot be used.
Cutting area depends on the MARK DISTANCE
and the settings.
l
l
It will detect the tilt of the printing from 2 registration marks, and cut
is performed matching the tilt of the print.
Feed direction of media Feed direction of media
2 axes adjustment (3POINT detection)
Supplement
Distance between the registration marks can be
adjusted.
Alignment registration mark can be used.
Cutting area depends on the MARK DISTANCE
and the settings.
l
l
l
It will detect the vertical and horizontal tilts from 3 registration marks,
and cut is performed matching the tilt of the print.
Precision of print and cut position will be higher than the 1 axis
adjustment.
Feed direction of media Feed direction of media
4 axes adjustment (4POINT detection)
Supplement
Distance between the registration marks can be
adjusted.
Alignment registration mark can be used.
Cutting area depends on the MARK DISTANCE
and the settings.
l
l
l
It will detect the left and right vertical tilts and upper and lower
horizontal tilt from 4 registration marks, and cut is performed
matching the tilt of the print.
Precision of print and cut position will be higher than the 2 axes
adjustment.
Feed direction of media Feed direction of media