GRAPHTEC FC8000 Series - Page 223

13-10
13-11
Symptom LCD Display Possible Cause Solution
E04011 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04012 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04013 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04014 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04015 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04016 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04017 It has exceeded detection area
while detecting the registration
mark.
Check the media. Check the print
position of the registration mark.
E04018 Media set lever was lowered. Reload the media and try again.
E04019 There was cancel operation by the
user.
Redo the process.
E04020 There is a defect in the detection
settings value.
Check the settings value.
E04021 Registration mark was not
detected in the auto detection
area.
Check the media. Check the print
position of the registration mark.