2-38
8
Press the [1] key (BLADE LENGTH TARGET).
BLADE LENGTH TARGET screen is displayed.
9
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
10
Confirm the settings and press the POSITION (
◄
) key
(PREVIOUS).
BLADE LENGTH TARGE is set and it will return to the BLADE
LENGTH setting screen.
Supplement
"T" is the target value of the blade length, and "H"
is the current blade height (amount).
11
Press the [2] key (CHECK).
The amount and direction to turn the adjustment knob is displayed.
CAUTION
Depending on the loaded media, the blade
might sink in to the media, making accurate
measurement impossible.
12
Turn the blade-length adjustment knob and adjust the cutter
blade length.
[2] Current blade length is displayed by pressing the [2] key
(CHECK), so adjust the blade length until it matches the
thickness of the media.
13
Press the [3] key (END).
Adjustment is completed and it will return to CONDITION screen (3/3).
14
Press the [CONDITION] key.
It will return to default screen.
To Next Page
Loading...
