GRAPHTEC FC8600 SERIES - Dual Configuration; Selection of the User

4-18
4
-
4-19
Dual Configuration
3
CAUTION
Cutting data will be cleared when USER is
switched.
FC8600 can save 2 sets of settings independently. This is called
dual configuration.
It is possible to quickly switch the different settings by the dual
configuration.
2 preferred sets of setting can be stored separately if there are
2 operators, or 2 different settings for different media can be
stored, making a quick change when the media is switched.
Dual configuration is done by selecting USER. There are USER 1
and USER 2 in the USER.
USER PRIORITY can be set for each USER. USER PRIORITY can
specify to make the settings by the USER who has computer
connected either by the key input, or from the "Cutting Plotter
Controller" in addition to the key input.
Selection of the User
Operation
Supplement
User name assigned in "Cutting Plotter Controller"
is displayed as the user name.
1
Press the [1] key (SELECT USER) in the default screen.
USER screen is displayed.
2
Press the [1] key (SELECT USER).
SELECT USER screen is displayed.
Supplement
It will return to USER screen without changing the
settings when you press the POSITION (
◄
) key
(PREVIOUS).
3
Press the [1] key (User No.1) or the [2] key (User No.2).
User is selected and it will return to USER screen.
Supplement
It will return to default screen without changing the
settings when you press the POSITION (
◄
) key
(CANCEL).
4
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to default screen.