GRAPHTEC FC8600 SERIES - Settings for OFFSET FORCE

7-20
7
-
7-21
Slight cut operation is performed before the actual cut operation to align the blade toward the cutting
direction. Lower FORCE is necessary compared with the normal cutting, so it is possible to set lower
FORCE as an OFFSET FORCE.
OFFSET FORCE is used to control the rotation of the blade with the tangential mode in addition to control
the blade direction at the beginning of the cut.
Operation
1
Press the [MENU] key.
TOOL setting screen (1/3) is displayed.
2
Press the [1] key (TOOL).
TOOLS SETTING screen (1/3) is displayed.
Supplement
It will return to TOOLS SETTING screen (1/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
3
Press the [4] key (OFFSET FORCE).
OFFSET FORCE setting screen is displayed.
Supplement
OFFSET FORCE can be set between 1 and 40.
4
Press the POSITION (
▲▼
) key and increase or decrease the
setting value.
POSITION
Supplement
It will return to TOOLS SETTING screen (1/3)
without changing the settings when you press the
POSITION (
◄
) key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to TOOLS SETTING screen (1/3).
6
Press the [MENU] key.
It will return to default screen.
Settings for OFFSET FORCE
7