GRAPHTEC FC8600 SERIES - Chapter 8: Settings Regarding Cutting Time; 8-1 Sorting the Cutting Data; 8-2 Perform Automatic Pre Feed When Cut Data is Received; 8-3 Perform Automatic Pre Feed When Media is Set (Initial Feed)

1-2
1
-
1-3
1
Checking the Contents
Check that all of the standard accessories shown below are present. If any accessory is missing, contact
your sales representative or the nearest Graphtec dealer.
AC power cord
1
USB cable (3-meter length)
1
DVD
1
• User's Manual (pdf)
• Windows driver/Cutting Plotter Controller
• Graphtec Studio/Cutting Master 3
Setup Manual, TO ENSURE SAFE AND CORRECT USE, Cutter Blade Manual
1 of each
Water-based fibertip pen (KF700-BK)
1
Cutter holder (PHP33-CB09N-HS)
1
Cutter blades
1
Water-based fibertip pen Adapter (PHP31-FIBER)
1
• Holder/Height adjustment tool
Media bracket (Enclosure)
1
• Media stocker x 2
• Stock roller x 2
• Socket head cap screws (M5) x 4
Stand
1
• Base assembly x 2
• Stand side bar x 2
• Center bar x 1 (Enclosure)
• Socket head cap screws (M5) x 20
• Allen wrench (for M5) x 1
Cloth basket (Enclosure)
1
• Cloth basket
• Mounts x 2
• Basket tubes (short) x 4
• Basket tubes (long) x 3
• Socket head cap screws (M5) x 4
• Joints x 4