GRAPHTEC FC8600 SERIES - Setting Origin Point When HP-GL Is Set

3-8
3-9
Setting Origin Point When HP-GL is Set
Set the origin point at the lower left or the center of the cutting area if the COMMAND is set to HP-GL.
There is no setting if the COMMAND is set to GP-GL.
Supplement
See "Settings of Controls from Computer"
P.11-1
about setting the COMMAND.
Operation
1
Press the [MENU] key.
MENU screen is displayed.
2
Press the POSITION (
▲
) key (I/F).
INTERFACE screen (1/3) is displayed.
3
Press the [2] key (ORIGIN POINT).
ORIGIN POINT setting screen is displayed.
4
Press the [1] key (LOWER LEFT) or the [2] key (CENTER).
Supplement
It will return to I/F screen (1/3) without changing
the settings when you press the POSITION [
◄
]
key (CANCEL).
5
Confirm the setting and press the [ENTER] key (SET).
Setting will be set, and it will return to I/F screen (1/3).
6
Press the [MENU] key.
It will return to the default screen.