7-12
7
-
7-13
DISTANCE ADJUST value corrects any deviation in the length of cut or plotted line segments, which
occurs depending on the media being used. DISTANCE ADJUST value for the deviation is specified as a
percentage of the total distance. For example, a setting of +0.05% adjusts a distance of 2 m (2,000 mm) by
2,000 x 0.05% = 1 mm, making 2,001 mm. DISTANCE ADJUST can be specified for each CONDITION No.
Supplement
DISTANCE ADJUST setting is maintained even if the power is turned off.
Next page
1
Press the [CONDITION] key.
CONDITION setting screen (1/3) is displayed.
Supplement
It will return to default screen without changing the
settings when you press the [CONDITION] key.
2
Press the POSITION (
▲
) key.
CONDITION setting screen (3/3) is displayed.
3
Press the [2] key (DISTANCE ADJUST).
DISTANCE ADJUST setting screen is displayed.
4
Press the POSITION (
◄►
) key and select the CONDITION No.
5
Press the [1] key (ON).
DISTANCE ADJUST becomes on and [3] key (X) and [4] key (Y) becomes
enabled.
Setting the Distance Adjust
4
To Next Page
Loading...
